Section 12 – Configuring IP Version 6 (IPv6)

Lab 12-1The Basics of Internet Protocol Version 6 (IPv6)
In this informational lab you will learn basics of the Internet Protocol Version 6 (IPv6) such as IPv6 addressing, IPv6 Auto Configuration, Address Types, General Operation and Subnetting.

Lab 12-2Configuring IPv6 Interface Addressing
In this lab you will learn how to configure an IPv6 unicast address on a Cisco Router interface and interface IPv6 address auto config used to generate an IPv6 address without DHCP.

Lab 12-3Configuring IPv6 Static routing
In this lab you will learn how to configure IPv6 (Internet Protocol version 6) static routing between two networks routers using an administrative static route and a default route.


Lab 12-4Configuring Basic IPv6 RIPng
In this lab you will learn how to configure the basics of Routing Information Protocol next generation (RIPng); an IPv6 version of the RIP protocol used in IPv6 dynamic routed networks.

Lab 12-5Configuring Basic IPv6 OSPFv3
In this lab you will learn how to configure a basic multi-area OSPFv3 IPv6 routed autonomous system using three routers and loopback simulated ethernet segments.

Lab 12-6Configuring IPv6 Access Control List
In this lab you will learn how to configure an IPv6 Access Control List to prevent IPv6 traffic from a specified source address or network to a specified destination host or network.